4-5
INTRODUCTION
- Your lift truck must be used with interchangeable equipment. These items are called: ATTACHMENTS.
- A wide range of attachments is available, guaranteed by MANITOU and designed to fit your lift truck perfectly.
- The attachments are delivered with a load chart concerning your lift truck. The operator’s manual and the load chart should be kept in the
places provided in the lift truck. For standard attachments, their use is governed by the instructions contained on this notice.
- Some particular uses require the adaptation of the attachment which is not provided in the price-listed options. Optional solutions exist,
consult your dealer.
Suspended loads MUST be handled with a lift truck designed for that purpose (see: 1 - OPERATING AND SAFETY INSTRUCTIONS: LOAD HANDLING INSTRUCTIONS:
H - TAKING-UP AND SETTING-DOWN A SUSPENDED LOAD).
Only attachments approved by MANITOU are to be used on our lift trucks (see: 4 - ADAPTABLE ATTACHMENTS IN OPTION ON THE RANGE: TECHNICAL
SPECIFICATIONS OF ATTACHMENTS). The manufacturer shall not be liable for any modification or adaptation of an attachment made without its knowledge.
Depending on their size, certain attachments may, when the jib is lowered and retracted, come into contact with the front tyres and cause damage to them, if
reverse tilt is activated in the forward tilt direction. TO PREVENT THIS RISK, EXTEND THE TELESCOPE TO A SUFFICIENT EXTENT FOR THE PARTICULAR LIFT TRUCK
AND ATTACHMENT SO THAT THIS CONTACT IS NOT POSSIBLE.
Maximum loads are defined by the capacity of a lift truck taking account of the attachment’s mass and centre of gravity. In the event of the attachment having
less capacity than the lift truck, never exceed this limit.
647421 (22/08/2017)
MT-X 625 Série 2-E3 + COMFORT
To Next Page
Loading...
Need help?
General