2-40
2
1
DESCRIPTION AND USE OF THE OPTIONS
1- PREHEATING ELEMENT
Enables the engine block to be kept warm during prolonged periods of stoppage and thus
improves engine starting.
SUPPLY CHARACTERISTICS OF PREHEATING SYSTEM:
• Rated range of power: 220-240V ; 50-60Hz
• Current consumption: 4,5A
• Class 1 equipment
• Equipment connectable only to Earth-Earth (TT) or Earth-Neutral (TN) circuits
• Installation category 2
ENVIRONMENTAL CONDITIONS FOR USE:
• Maximum ambient temperature for using preheating: +25°C
• Pollution level 2
CONDITIONS FOR CONNECTION AND USE OF PREHEATING:
- The preheating system should not be used for an external ambient temperature higher than + 25°C.
- It is essential that the power supply to the preheating system is:
• Effected with a cable that conforms to the installation standards in force and contains a protective earth conductor.
• Contains an appropriate isolation system.
• Incorporate an appropriate safety system against short circuits (fuses or circuit breaker) and a differential circuit breaker with 30
mA sensitivity.
- Only connect to and disconnect from the power supply while the unit is off and the I.C. engine is stopped.
2 - NUMBER PLATE LIGHTING
3 - MODCOD ANTI-THEFT SYSTEM
OPERATION
- Switch on lift truck ignition, red LED 1 will flash.
- Enter your user code followed by “V” to validate, green LED 2 will light.
- Start the lift truck within the next 60 seconds; otherwise the anti-theft system will be reactivated
and red LED 1 will flash.
NOTE: If you make a mistake when entering the code, press key “A” to cancel and re-enter
the code in full. If you wait more than 5 seconds between key presses, the code entry
procedure will be aborted, the anti-theft system will be reactivated and the red LED will
flash.
4 - FINTRONIC ANTI-START SYSTEM
OPERATION
- Switch on the lift truck and set the black key A next to the antenna B (maximum 80 mm).
- Wait a few seconds for red LED C to go out before starting the lift truck.
NOTE: You can restart the lift truck within 20 seconds of stopping it: after this time, the anti-start
system reacts and red LED C flashes.
647421 (22/08/2017)
MT-X 625 Série 2-E3 + COMFORT
To Next Page
Loading...
Need help?
General