1-7
STACKY operating and safety instructions2012.12
INSTRUCTIONS FOR THE OPERATOR
PREAMBLE
All the stackers and tools described in these instructions are standard stackers and standard tools respectively. The tools are only
interchangeable in the case of standard tools and standard stackers.
The risk of accident while using, servicing or repairing your stacker can be reduced if you follow the safety instructions
and safety measures detailed in this operator’s manual.
Only the operations and manoeuvres described in this operator's manual must be performed. The manufacturer cannot foresee
all possible hazardous situations. Consequently, the safety instructions given in the operator's manual and on the stacker itself
are not exhaustive.
As the operator, you must foresee at all times, within reason, the possible risk to yourself, to others or to the stacker itself when
you use it.
Failure to follow the safety and operating instructions, or the instructions for repairing or servicing your stacker may lead
to serious, even fatal accident.
GENERAL INSTRUCTIONS
A - OPERATOR'S MANUAL
Read the operator's manual carefully.
The instruction manual must always be kept in good condition and available to the operator.
You must report any plates and stickers which are no longer legible or which are damaged.
B - AUTHORISATION FOR USE
Only qualied, authorized personnel may use the stacker. This authorization is to be given in writing by the person
in the company, responsible for the use of the stacker, and must be carried by the operator at all times.
The operator has no authority to authorise the stacker to be operated by another person.
C - MAINTENANCE
The operator must immediately advise his superior if his stacker is not in good working
order or does not comply with the safety instructions.
Drivers are prohibited from carrying out any repairs or adjustments themselves, unless
they have received appropriate training. If appointed to do so, they are responsible for
keeping the stacker in a clean condition.
The operator is responsible for carrying out daily maintenance operations
(see : 3 - MAINTENANCE : A - DAILY CHECKS).
D - MODIFICATION OF STACKER
For your own safety and that of others, you must not change the structure and settings
of the various components used in your stacker by yourself (hydraulic pressure,
limiter calibration, addition of extra equipment, unapproved tools, etc.). In this event,
the manufacturer cannot be held liable.
E - LIFTING PEOPLE
The use of working equipment and load lifting tools to lift people is forbidden (g. E1).
F - STACKER DIRECTION OF TRAVEL
The stacker is travelling in the forward direction when the operator is holding the tiller
arm with one hand, and the stacker is behind him (g. F1).
F1
E1
To Next Page
Loading...
Need help?
General
