Manitou STACKY 10 FR S16 User Manual

1-10
STACKY operating and safety instructions 2012.12
- Move the stacker smoothly at an appropriate speed for the operating conditions
(ground prole, load on the stacker),
- Do not use the lifting or lowering controls when the lift truck is moving,
- Approach bends, narrow passages or swing doors, as well as any sector where
visibility is reduced, at reduced speed,
- Make sure you are in control of your speed under all circumstances,
- Brake gently, never abruptly,
- Do not leave the stacker unattended with the load raised (g. F3),
- Look where you are going and always make sure you have good visibility along
the route,
- Leave a margin of safety when manoeuvring around obstacles,
- The operator must always remain uphill of the stacker on a ramp,
- Ramps must not be taken perpendicular to the axis of the slope,
- Never turn the stacker around on a ramp.
The operator must not move the stacker with the fork or tool in the raised position,
whether laden or unladen (g. F4).
The operator must not pass the load over a person when moving the stacker (g. F5).
INSTRUCTIONS
- Always move the stacker with the forks or tool in the transport position, i.e. at 150
mm from the ground,
- Place the tiller arm within the driving zone (2) (g. F6) in order to unlock the electrical
safety system,
- The orientation of the tiller arm determines the direction of the stacker,
- When moving the stacker, the operator must walk in front of the machine,
- Gradually push one of the buttery control switches up or down (1) (g. F7)
depending on the chosen direction of travel.
As the stacker is tted with an electronic speed controller, its speed is progressive and
increases according to the angular position of the buttery control switch.
- To brake the stacker, release the buttery control switch, which will return to the
neutral position, gradually bringing the stacker to halt,
- To stop the stacker, fully lower or raise the tiller arm (1) (g. F6) or (3) (g. F6), which
will actuate the electrically-operated brake.
The tiller arm automatically returns to the vertical position as soon as it is released.
The parking brake is then operated, stopping the stacker immediately.
The end of the tiller arm is tted with an anti-crushing safety device (2) (g. F7) that
protects the operator by reversing the direction of travel as soon as it is pressed. The
stacker will only stop when the pressure on the safety device stops or after 5 seconds.
This only applies when the stacker is in forward mode.
The button with a tortoise symbol (3) (g. F7) moves the stacker at slow speed. This
function is very useful when manœuvring in conned spaces. When the button is
activated, the stacker travels at 30 % of its nominal speed. This function can be used
regardless of the control lever position (brake or drive).
- Hold down the slow speed (tortoise) button (3) (g. F7),
- Push the buttery control switch up or down (1) (g. F7) according to the chosen
direction of travel.
F4
F5
1 2
1
3
F7
F3
3
2
1
F6

Manitou STACKY 10 FR S16 Specifications

General

Brand	Manitou
Model	STACKY 10 FR S16
Category	Lifting Systems
Language	English