4-5
2012.12 Tools - STACKY
INTRODUCTION
The tools shown in this instruction manual are standard tools. They are interchangeable and can be mounted on any standard
stacker.
A wide range of standard tools, specially designed and perfectly suitable for your stacker is available and guaranteed by
MANITOU.
The use of these standard tools is governed by the instructions contained herein.
Certain special applications require the use of non-standard tools that are specic to their stacker and are not interchangeable.
Only tools approved by MANITOU are to be used on our stackers. The manufacturer shall not be liable for any
modications or adaptations made to its tools without its written approval.
CAUTION : the capacities (maximum load and centre of gravity) are specic to each tool.
It is forbidden to handle a load weighing more than the eective capacity indicated on the tool’s name plate.
Suspended loads MUST be handled with a stacker designed for that purpose (see : 1 - OPERATING AND SAFETY
INSTRUCTIONS : LOAD HANDLING INSTRUCTIONS : I - PICKING-UP AND SETTING-DOWN A SUSPENDED LOAD).
To Next Page
Loading...
