Manitowoc convotherm 4 Operating And Installation Instructions

3 Installation location requirements
Operating and Installation Instructions UL 17
3 Installation location requirements
Prerequisites
The following prerequisites must be met:
 You have read and understood the combi oven’s installation manual.
Supporting surface
The supporting surface must have the following characteristics:
 The supporting surface must be flat and level.
 The supporting surface must be able to bear the sum of the unit weight (including the maximum
permissible loading weight (see 'Technical Data' section in the installation manual), the accessories’
weight, and the stacking kit weight (stacking kit weights listed below).
Stacking kit weights
Depending on the specific size and model being used, the stacking kit will weigh between 66 and 110
lbs (without units and accessories).
Stacking kit combinations featuring electrical and gas units
The following applies to stacking kit combinations featuring electrical and gas units:
 If the electrical unit is on the bottom: Use an electrical stacking kit (unit on ES/EB unit)
 If the gas unit is on the bottom: Use a gas stacking kit (unit on GS/GB unit)

Manitowoc convotherm 4 Specifications

General

Brand	Manitowoc
Model	convotherm 4
Category	Kitchen Appliances
Language	English