Manitowoc convotherm 4 Operating And Installation Instructions

2 For Your Safety
Operating and Installation Instructions UL 8
2 For Your Safety
The purpose of this section is to provide you with all the information on hazards and safety measures
that you will need (in addition to the unit safety information provided in the operating and installation
manual) in order to safely work with/on the stacking kit without putting yourself and others at risk.
Read this section very carefully.
Transportation and setup
When transporting and setting up the combi oven, keep the following hazards in mind and take the
actions required in order to eliminate and/or minimize these hazards:
Risk / hazard Where and in which situations will the
risk/hazard exist?
What to do / safety equipment
Explosion hazard posed
by gas leaks
Whenever the connections are not
disconnected before moving the unit
Make sure to only have gas technicians
from an authorized installation company
work on the gas system
Disconnect the connections
Safety device:
 Wall anchoring kit
Risk of electric shock
posed by live parts
Whenever replacing the bottom unit’s dry
air intake
 Work on the unit’s electrical compo-
nents should be performed exclusively
by a qualified electrician from an au-
thorized service company
 Work professionally
Before removing the covers:
 De-energize all connections
 Lock out and tag out all switches
 Make sure that the unit is
de-energized
Crush hazard if the unit
topples over
 Whenever moving the units across
uneven surfaces or after bumping into
an obstacle
 Whenever the connections are not
disconnected before lifting
 Whenever the unit is not positioned
correctly
 Whenever the supporting surface is
not stable and even
 Secure the units so that they cannot
topple over
 Use suitable equipment and assembly
aids to transport the units
 Set up the units on an even and stable
supporting surface
 Disconnect the connections
 Place the unit on the locating pins
correctly and screw it in place
Safety device:
 Wall anchoring kit (optional)
 Locating pins and screw joints
 Marine model: Feet that can be
screwed onto the floor
 Whenever the top unit is loaded with a
lot of weight
 When moving the stacking kit
 When placing the unit on its back
Exercise caution when performing
maintenance work
Risk of injury due to
excessive exertion
 When stacking the stacking kit and the
unit
 Whenever using a spirit level to level
the units
 Whenever mounting the center adapt-
er
 Whenever placing the unit on its back
and then lifting it up again
 Do not lift or carry too much weight!
 Only with a sufficient number of people
or suitable equipment

Manitowoc convotherm 4 Specifications

General

Brand	Manitowoc
Model	convotherm 4
Category	Kitchen Appliances
Language	English