6 Installation
Operating and Installation Instructions UL 39
All unit models:
3.
Use a Phillips screwdriver to remove the five screws at the top
of the unit.
You will not be using these screws anymore.
4.
Slightly lift the unit’s top panel in the dry air intake’s area.
5.a
Pull the dry air intake pipe as far up as possible (1).
Turn the venting valve to the right (2) and pull the pipe down-
wards (3).
Dispose of the pipe that is cut at an angle. You will not be
needing it anymore.
5.b
Turn the venting valve back to its initial position.
Make sure that the gasket ends up in its correct position.
6.
Apply a bit of lubricant (e.g., soap) to the air vent.
To Next Page
Loading...
