To Next PageTo Next PageWhat to do if gear box on motor is faulty in Manitowoc Beverage Dispenser?
If the gear box on the motor of your Manitowoc Beverage Dispenser is faulty, you should replace the Ice Crusher Motor Assembly. If the Crusher Axle is broken, replace it.
Why doesn't the crusher dispense door open on my Manitowoc Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI Beverage Dispenser?
If the crusher dispense door on your Manitowoc Beverage Dispenser does not open, it could be due to a faulty door solenoid, which would need replacement. Alternatively, there may be loose wiring to the solenoid, so check the wiring.
What if my Manitowoc Beverage Dispenser has no lights, the crusher won't work, and the transformer breaker is blown?
If there are no flashing lights on the keypad of your Manitowoc Beverage Dispenser, the fluorescent light was on, the crusher and whole ice dispenser will not function, and the transformer breaker is blown, it is possible that water shorted out the wiring harness on the valves only. Clean up the water and reset the transformer.
General| Brand | Manitowoc |
|---|---|
| Model | Flav’R-Pic FRP-250, Flav’R-Pic FRP-250SCI |
| Category | Beverage Dispenser |
| Language | English |
Guide for owner/operator and installer.
Lists beverage/ice dispenser models covered.
Details about baffles and manual fill lids for dispensers.
Information on optional legs and serial number identification.
Details on warranty terms, exclusions, and return procedures.
Assists qualified installers with start-up services.
Provides physical dimensions and footprint for FRP-250/SCI.
Specifies location criteria and clearances for dispensers and ice machines.
Lists major components needed for various system installations.
Details baffle installation for 'S' and 'Q' series ice machines.
Covers general wiring, circuit ampacity, voltage, and grounding.
Details recommended plumbing and diagram location.
Routing purge tube and drain connections.
Comprehensive guide for unit setup, capacities, and system pressures.
Instructions for setting syrup and water ratios using a brix cup.
Detailed brixing steps for nozzles N1, N2, N3, N4, N5, N6.
Final steps for cleaning and preparing the dispenser for use.
Diagram and description of the internal carbonation beverage dispensing system.
Identifies key parts of the Flav'R-Pic dispenser.
Explains ice dispensing, storage, and beverage valve functions.
Details how tap water is carbonated and mixed with CO2.
Covers syrup location, BIB systems, pumps, and auto bag selectors.
Explains adjustable and non-adjustable agitation timers.
Focuses on ice delivery switch adjustment for non-crushing units.
How to check brix externally and set default ice dispense settings.
Details on setting carb/non-carb drinks and flavor shot durations.
Explains control logic, sequences, and ADA touch pad configurations.
Step-by-step guide for cleaning the dispenser exterior and nozzles.
Instructions for cleaning the ice bin and a list of maintenance checks.
Guidelines to keep the dispenser in optimal condition.
Instructions on how to disassemble parts for cleaning and maintenance.
Detailed steps for removing and reinstalling the ice crusher assembly.
Guide for removing and replacing the serviceable gear motor.
Steps for sanitizing beverage systems and bag-in-box circuits.
Instructions for removing and installing front graphic medallions.
Common problems, causes, and corrections for dispenser issues.
Specific troubleshooting for crushed ice dispensing problems.
Diagnosing issues with water, syrup, CO2, and beverage ratios.
Troubleshooting flavor syrup dispensing and pump operation problems.
