Part Number 000012545 Rev 02 11/16 19
Section 2 Installation
Installation Check List
Is the Ice Machine level?
Have all of the electrical and water connections
beenmade?
Has the supply voltage been tested and checked
against the rating on the nameplate?
Is there proper clearance around the ice machine forair
circulation?
Is the ice machine grounded and polarity correct?
Has the ice machine been installed where ambient
temperatures will remain in the range of 35° - 110°F
(1.6° - 43.3°C)?
Has the ice machine been installed where the incoming
water temperature will remain in the rangeof 35° - 90°F
(1.6° - 32.2°C)?
Is there a separate drain for the potable water,
binandwater-cooled condenser?
Are the ice machine and bin drains vented?
Are all refrigerant lines free from contact with
othercomponents?
Are all electrical leads free from contact with
refrigeration lines and moving equipment?
Has the owner/operator been instructed
regardingmaintenance and the use of our Cleanerand
Sanitizer?
Has the owner/operator completed the
warrantyregistration card?
Has the ice machine and bin been sanitized?
Is the ice thickness set correctly? (Refer to
OperationalChecks to check/set the correct ice
bridgethickness).
Additional Checks for Remote Models
Does the remote condenser fan operate properly
afterstart-up?
Has the remote condenser been located where
ambient temperatures will remain in the range of -20°-
120°F (-29 - 49°C).
Is the line set routed properly?
Are both refrigeration lines to remote condenser run so
they do not lay in water and are properly insulated?
Before Starting the Ice Machine
All ice machines are factory-operated and adjusted before
shipment. Normally, new installations do not require any
adjustment.
To ensure proper operation, follow the Operational Checks
in Section 3 of this manual. Starting the ice machine and
completing the Operational Checks are the responsibilities
of the owner/operator.
Adjustments and maintenance procedures outlined in this
manual are not covered by the warranty.
n
Warning
Potential Personal Injury Situation
Do not operate equipment that has been misused,
abused, neglected, damaged, or altered/modified from
that of original manufactured specifications.