22 Part Number 000012545 Rev 02 11/16
Operation Section 3
Operational Checks
GENERAL
All ice machines are factory-operated and adjusted before
shipment. Normally, new installations do not require any
adjustment.
To ensure proper operation, always follow the Operational
Checks:
• when starting the ice machine for the first time
• after a prolonged out-of-service period
• after cleaning and sanitizing
NOTE: Routine adjustments and maintenance procedures
are not covered by the warranty.
MINIMUM/MAXIMUM SLAB WEIGHTS
Adjust ice thickness to meet chart specifications.
Model Minimum Ice Weight
Per Cycle
Maximum Ice Weight
Per Cycle
K0250 3.4 lbs
1542 g
3.9 lbs
1769 g
K0350 3.4 lbs
1542 g
3.9 lbs
1769 g
K420 3.4 lbs
1542 g
3.9 lbs
1769 g
K0500 4.125 lbs
1871 g
4.75 lbs
2154 g
K0600 4.125 lbs
1871 g
4.75 lbs
2154 g
K1000 7.25 lbs
3288 g
7.75 lbs
3515 g
K1350 12.8 lbs
5805 g
14.4 lbs
6532 g
K1800 12.8 lbs
5805 g
14.4 lbs
6532 g
ICE THICKNESS CHECK
After a harvest cycle, inspect the ice cubes in the ice storage
bin. The ice thickness float switch is factory-set to maintain
the ice bridge thickness at 1/8" (3 mm).
NOTE: Make sure the water curtain is in place when
performing this check. It prevents water from splashing out
of the water trough.
1. Inspect the bridge connecting the cubes. It should be
about 1/8" (3 mm) thick.
2. If adjustment is necessary, turn the ice thickness
float switch clockwise to increase bridge thickness,
counterclockwise to decrease bridge thickness. Adjust
to achieve a 1/8" (3 mm) bridge thickness.
NOTE: The float can be adjusted with a 3/4" wrench while
the water trough is in place. Test run two cycles to verify
water level.
Ice Thickness Float
Switch Adjustment
To Next Page
Loading...
Need help?
General