22
5001192
Revision 03 February, 2003
Installation and Service Manual
CORRECTION
Remove the gear motor.
Some models contain a
shaft extension held on
with a roll pin. If the roll
pin is broken, replace. If
the roll pin is good, re-
place the gear motor.
If not sufficient ice, add
additional ice to bin.
If the ice does not meet
the dispensing param-
eters as described on
page 5 replace the ice.
Adjust or replace the agi-
tation timer as required.
The ice deflection baffle
is to be installed between
the dispenser and the ice
maker. Install deflector if
missing.
Repair top mounted ice
maker to reduce amount
of water entering the dis-
penser.
Clean the bin drain.
Replace ice with accept-
able type.
Adjust ice machine to
make a good, complete,
not hollow piece of ice.
Install deflector if missing.
CONDITION
Dispenser crushes ice as
it dispenses.
Ice continuous to dispense
or dispenses by itself.
INVESTIGATION
Is there an ice maker on
top of the dispenser?
Is the agitation timer (if
equipped) set properly?
Is the ice door opening
fully when the dispenser
operates?
Does ice continue to
dispense after the cup
has been pulled away?
Does the ice dispense
by itself without anyone
around the dispenser?
CHECK / HOW
TO CHECK
Is there at least 7.5 cm (3
in) between the top of the
ice and the top of the dis-
penser bin?
Timer should agitate for
two seconds every four
hours.
The ice door should open
a minimum of 3.8 cm
(1.5in).
Does the gear motor con-
tinue to run during this
time?
Does the dispenser do
this at regular intervals?
TROUBLESHOOTING
To Next Page
Loading...
Need help?
General