Manitowoc F2280-29
Published 07-21-21
MLC300 Lubrication Guide
NOTE 1 Service after first 200 hours of operation is
required to remove metal particles and other
impurities collected during the initial run-in of the
gearboxes.
NOTE 2 Before assembly, make sure that all the grease
holes are open.
NOTE 3 Before assembling the bearing, hand pack the
bearing with grease.
Item Description Required Service
Prior to Operation
A1 VPC Gearbox Oil Level Sight Glass Check the level, fill with gear oil through fill plug.
A2 VPC Gearbox Oil Fill Plug Fill to the proper level with gear oil.
A3 VPC Roller Assembly (each roller) Grease each fitting (see NOTE 2).
A4 VPC Roller Bearing (each roller) Grease each (see NOTE 3).
After First 200 Hours of Operation
(see NOTE 1)
M1 VPC Gearbox Oil Drain Plug Drain and refill with gear oil through fill plug.
Every 200 Hours of Operation or Monthly (whichever comes first)
M2 VPC Gearbox Oil Level Plug Check the level, fill with gear oil through fill plug.
M3 VPC Gearbox Oil Fill Plug Fill to the proper level with gear oil.
M4 VPC Drive (each gearbox) Grease each fitting.
Every 1000 Hours of Operation or Semiannually (whichever comes first)
S1 VPC Gearbox Oil Drain Plug Drain and refill with gear oil through fill plug.
S2 VPC Roller Assembly (each roller) Grease each fitting (see NOTE 2).
To Next Page
Loading...
