You will notice throughout this Operator’s Manual Safety Rules and Important Notes. Make sure you understand and obey these
warnings for your own protection.
I. SPECIAL SAFETY INFORMATION
II. SAFETY & WARNINGS
III. SAFETY DECAL INFORMATION
An important part of the safety system incorporated in this tiller are the warning and information decals found on various parts of
the tiller. These decals must be replaced in time due to abrasion, etc. It is your responsibility to replace these decals when they
become hard to read.
Safety Rules & Warnings
Improper use or care of this tiller or failure to wear
proper protection can result in serious injury.
Read and understand the rules for safe
operation and all instructions in this manual.
Wear hearing and eye protection.
To reduce the potential for accidents, comply
with the safety instructions in this manual.
Failure to comply may result in serious
personal injury, and/or equipment
and property damage.
The engine exhaust from this product contains
chemicals known to the State of California to cause
cancer, birth defects or other reproductive harm.
Attention: This symbol points out our
important safety instructions.
When you see this symbol,
heed it’s warning!! Stay alert!!
P/N 430057P/N 400630
Cutting hazard;
keep feet and
hands away from
rotating tines.
Don’t operate
indoors
Caution: when assembling
the handles, make sure fuel
tank faces operator. This is
the rear of the tiller, refer to
assembly instructions
Incorrect assembly.
Wear ear and
eye Protection.
Do not carry
the tiller in this
position.
Don’t fuel, refuel, or
check fuel while smoking,
or near an open ame or
other ignition source.
Mix unleaded gas
with 2 cycle 50:1 oil.
Read operators manual before
using tiller, or performing any
repair or maintenance. Keep
operators manual in a safe place.
PRODUCT EMISSION DURABILITY
The 300 hour emission durability compliance period
is the time span selected by the manufacturer
certifying the engine emissions output meets
applicable emissions regulations, provided that
approved maintenance procedures are followed as
listed in the Maintenance Section of this manual.
An Emission Control
Label is located on
the engine (This is
an EXAMPLE ONLY,
information on label
varies by engine
FAMILY.)
430088 Mantis 2-Cycle Tiller Color Cover.indd 3 7/10/14 7:49 AM
To Next Page
Loading...
Need help?
General
