10 Operator’s Manual
Assembly (Continued)
IMPORTANT NOTE:
Be sure you have proper throttle movements and that
the throttle cable is not wrapped or twisted around the
handle bar. Hold down the lockout lever, fully squeeze
the throttle trigger and let go. The throttle triangle must
click in both directions. If there is any doubt, remove
air lter and visually check that the throttle triangle hits
both the idle screw and the full open stop. THIS MUST
BE DONE BEFORE STARTING THE ENGINE.
IMPORTANT NOTE:
Before you use your MANTIS Tiller, read the
Safety Rules & Warnings on pages 3-5
IMPORTANT NOTE:
Make sure you have installed the handles properly.
When you stand behind your tiller, holding the handles,
the fender warning label should face you.
Improper Throttle installation can cause tines to rotate unexpectedly.
7990
UPPER HANDLE ASSEMBLY
1
• Lift the upper handle until it lines up
with the lower handle.
•
Insert carriage bold (T42) from outside in.
• Screw on knob (T12) and fully tighten
the knob at the pivot point.
• Follow the same steps to install the
other upper handle onto the other
lower handle.
• Use the clip (T9) to secure the throttle
cable and wire in place on the lower
handle.
3
2
• Cap the exposed bolt with an acorn
nut (T13) and tighten with your 7/16”
wrench until snug. Do not over tighten.
• Now install the handle brace. Line it up with the holes
on the upper handles. Then insert a cap screw (T15)
and a lock nut (T14) on either side.
• Use a wrench to tighten cap screws and lock nuts.
• Now use wrench to tighten all nuts and bolts rmly and
securely.
4
To Next Page
Loading...
Need help?
General
