EasyManua.ls Logo

Marantz AV8003 - Check 3: Circuit Timing for Normal Operation

Marantz AV8003
219 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
Check 3
For the product to start operating normally when the power
is turned on, the circuit connected to each input port of _P
DOWN, _P LINE FAIL and 5V_DOWN needs to be operating
normally.
• TIMING CHART
Normal operation when the power is turned on
Check 3
電源ON時に製品が通常動作を開始するためには、下図の様な
Timing で _P DOWN, _P LINE FAIL, __5V_DOWN の各入
力Portで接続されている回路が正常動作している必要がありま
す。
• TIMING CHART
電源ON時の正常動作
_PRE_MUTE
(IC20: Q5, 14pin)
(OUT)
MUTE RELAY
:OFF
_STAND BY (136pin)
(OUT)
_STAND BY LED (94pin)
(OUT)
_P_DOWN (25pin)
(IN)
_P_LINE_FAIL (135pin)
(IN)
_5V_DOWN (137pin)
(IN)
Hi
:P_LINE=OK
_STAND BY
:解除
AC POWER SUPPLY: POWER ON
STANDBY LED
:LIGHT OUT
STAND BY LED
:消灯
①
3.5 sec後、検出開始
INCONSTANT
電源立ち上げ:正常時
7 sec
3.5 sec
②
MUTE RELAY:ON
MUTE
:OFF
MUTE
:OFF
FRONT_OFF
(IC20: Q4, 7pin)
(OUT)
Low LEVEL
200 msec
3.5 sec
後、検出開始
③
+5VDD=OK
MUTE
:ON
各ch MUTE
EACH CHANNEL MUTE
(OUT)
1 sec
_STAND BY
:CANCEL
INCONSTANT
不定
不定
After 3.5 sec, the detection start
After 3.5 sec, the detection start