The updating of software takes about 1 minute.
• Mode 6: Update/Download DMP Sub CPU's software to
internal Flash-ROM.
This mode is to update/download the software for DMP
Sub CPU.
The target devise is internal flash ROM of CPU (IC51) on
CUP12079Z (STAND BY PWB).
The unit needs to be set writing condition, by three front
buttons.
The updating of software takes about 20 seconds.
NECESSARY EQUIPMENT
The following items are required for updating/downloading.
Windows PC (OS: Windows2000 or WindowsXP) with
Serial port.
RS-232C Dsub-9 pin cable (female to female/straight
type)
Update software to MAIN CPU. (FlashUpdate_v110.exe,
etc... in main folder)
Update software to flash ROM for DSP. (da708_writer.
exe, etc... in TI_DSP folder)
Update software to HDMI CPU. (wr36049.exe, etc... in
HDMI folder)
Update software to HD Radio CPU and Flash ROM.
(FlashSta.exe, etc... in HDRadio folder)
Update software to DMP Sub CPU. (FlashSta.exe, etc...
in DMPSub folder)
Use RS232C Dsub-9 pin cable (female to female/straight
type) to connect PC and the RS-232C port in rear panel of
the unit, when updating/downloading each of software.
書き込みにかかる時間は約1分です。
• Mode 6: Update/Download DMP Sub CPU's software to
internal Flash-ROM.
このモードはDMP Subマイコンの更新および書き込み用で
す。
基板CUP12079Z (STAND BY PWB) のIC51のマイコン内
部のフラッシュROMに書き込みます。
本機のフロントボタン3つから書き込みモードにする必要が
あります。
書き込みにかかる時間は約20秒です。
必要機器
下記は更新および書き込みに必要な機器です。
Windows PC (OS : Windows2000 またはWindowsXP) で
Serial ポートのあるもの
RS-232C ストレートケーブル(9Pin メス-9Pin メス)
MAINマイコン用書き込みソフトウェア(MAINフォルダ内
FlashUpdate_v110.exe、など)
DSPフラッシュROM用書き込みソフトウェア(DSPフォル
ダ内da708_writer.exe、など)
HDMIマイコン用書き込みソフトウェア(HDMIフォルダ内
wr36049.exe、など)
HD Radioマイコン、およびモジュール用書き込みソフトウ
ェア (HDRadioフォルダ内 FlashSta.exe、など)
DMP Subマイコン用書き込みソフトウェア(DMPSubフォ
ルダ内 FlashSta.exe、など)
それぞれのソフトウェアを更新および書き込みする場合、RS-
232Cケーブルで本機リアパネルのRS232Cコネクタと
Windows PCのSerialポートを接続します。