Marantz AV8802/U1B - Updating by DPMS

2. Updating by DPMS
Downloadthelatestrmwarefromtheinternetandupdatethermware.
2.1. Network Connection
(1) System Requirements
• A broadband internet connection
• Modem
• Router
• Ethernet cable (CAT-5 or greater recommended)
(2) Settings
2.2. Checkandupdatethermware
Checkwhethernewrmwareisavailable.Itisalsopossibletocheckapproximatelyhowlongtheupdatewilltake.
(1) Press the button "
SETUP
" on the remote control to display the GUI menu.
(2) Press the cursor button to select "
General
"→"
Firmware
"→"
Update
"→"
Check for Update
".
(3) Press the button "
ENTER
".
•Thelatestrmwareversionuploadedtoourwebsiteisdisplayed.
•Proceedto(4)ifnewrmwareisavailableonourwebsite.
•Ifthelatestrmwareisalreadyinstalled,pressthebutton"
SETUP
" to exit the menu.
(4) Select "
Start
" using the cursor buttons and then press "
ENTER
".
• The power display lights in red and the GUI screen display disappears during the update.
The remaining time of the update is shown on the display of the unit.
• The normal status resumes after the update is completed.
--- Precautions for Updates ---
• The environment and settings must allow connection to broadband Internet for updates.
• Never turn off the power before an update is completed.
• It takes around 1 hour to complete the update.
Once an update is started, normal operations cannot be performed until it is completed.
The GUI menu settings and image adjustment settings of this unit may be initialized.
Takenoteofyoursettingsbeforehandandrecongurethemaftertheupdate.
Modem
Internet
Computer
ComputerLAN port / Ethernet connector
ETHERNET connector
Router
To WAN port
To LAN port
To LAN port
84