Switching the reception information for
the currently tuned in DAB station
1
Press INFO during DAB reception.
Dynamic Label
Segment:
Text data included in the broadcast is
scrolled.
Station Name: The service station name is displayed.
Program Type:
The category of the tuned in station is
displayed.
Ensemble Name: The ensemble name is displayed.
Frequency: The frequency is displayed.
Signal Quality:
The reception signal intensity is
displayed (0 to 8).
0
If the reception signal intensity is 5 or
greater, the program can be received
without noise.
Audio Information:
The mode of the currently tuned in
station and its bit rate are displayed.
RDS search
RDS is a broadcasting service which allows a station to send additional
information along with the regular radio program signal.
Use this function to automatically tune to FM stations that provide the RDS
service.
Note that the RDS function only works when receiving RDS compatible
stations.
1
Press SEARCH during FM reception.
This displays the search menu.
2
Use ui to select “RDS Search”, then press ENTER.
3
Press o p.
The search for RDS stations begins automatically.
0
If an RDS broadcast station cannot be found, “No Station”
appears in the display.
0
The display switches between Frequency, Program Type, Clock time and Radio
Text each time the INFO is pressed.
0
The operations described below selecting “RDS Search” will not function in areas
in which there are no RDS broadcasts.
Contents
Connections Playback Settings Tips Appendix
45
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
