Marantz M-CR412 - Auto-Standby

Auto-Standby
If there is no input signal and operation for 15 minutes, this unit
automatically enters standby mode.
On
(Default):
The unit goes into standby after 15 minutes.
Off: The unit does not go into standby automatically.
0
When the input source is “Tuner”, this unit automatically enters the standby mode
when no operation is performed for 8 hours.
Bluetooth
Stopping Bluetooth function reduces a source of noise that affects sound
quality, enabling higher sound quality playback.
On
(Default):
Enables the Bluetooth function.
Off: Disables the Bluetooth function.
0
When this unit enters standby and “Bluetooth” is set to “On”, Bluetooth also enters
standby. While Bluetooth is in standby, this unit powers on automatically if it is
connected to a paired device via Bluetooth.
Reset
Perform this procedure if the display is abnormal or if operations cannot be
performed. Restores the contents of each setting to the factory settings.
Make settings again.
Reset Default: Unit is initialized.
Cancel: Unit is not initialized.
0
Selecting “Reset Default” also resets all Bluetooth device pairing information
saved to this unit.
Contents Connections Playback Settings Tips Appendix
71
Front panel Rear panel
Remote control
unit
Index