0
When “TV Auto-Play” is set in the menu, this unit automatically turns on when the
TV connected to the unit is turned on, and the input source switches to “Optical In
1” or “Optical In 2”. (v p. 69)
NOTE
0
Do not input non-PCM signals, such as Dolby Digital, DTS and AAC. This causes
noise and could damage the speakers.
o
Specifications of supported audio formats
See “DIGITAL IN” (v p. 93).
Playing analog input
1
Prepare for playback.
Check the connection, then turn on this units. (“Connecting an
analog device” (v p. 25))
2
Press ANALOG IN to switch the input source to
“Analog In”.
3
Play the component connected to this unit.
Contents Connections Playback Settings Tips Appendix
54
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
