Power does not turn on / Power is turned off
Power is not turned on.
0
Check whether the power plug is correctly inserted into the power outlet. (v p. 28)
0
This unit is in standby mode. Press the X button on the unit or the POWER X button on the remote control. (v p. 30)
Power automatically turns off.
0
The sleep timer is set. Turn on the power again. (v p. 57)
0
The unit is set to auto standby mode. The auto standby mode automatically switches the unit to standby if there are no operations for more than 15
minutes. To disable auto standby mode, set “Auto-Standby” in the menu to “Off”. (v p. 71)
LED is flashing
Flashing red. (Flashes in 0.25-second intervals)
0
This unit’s amplifier circuit has failed. Disconnect the power and contact the repair center.
0
Core wires of two speakers are touching each other or a core wire is sticking out of the terminal and touching the set’s rear panel, activating the
protection circuit. First unplug the power cord, then twist the core wires tightly or terminate the speaker cables, then reconnect.
Flashing red. (Flashes in 2-second intervals)
0
Protection circuit activated due to a rise in internal temperature. Turn off the power, wait for the set to fully cool down, then turn the power back on.
Contents
Connections Playback Settings Tips Appendix
77
Front panel Rear panel
Remote control
unit
Index
To Next Page
Loading...
