Explanatory Photos for DISASSEMBLY
• For the shooting direction of each photos used in this manual, see the photo below.
• A, B, C and D in the photo below indicate the shooting directions of photos.
• The photographs with no shooting direction indicated were taken from the top of the unit.
• Photos of NR1508 U are used in this manual.
The viewpoint of each photograph
(Shooting direction : X) [View from the top]
Proceeding : TOP COVER → WiFi ANT
(1) Remove the INSULATION SHEET. Cut the wire clamps. Remove the tape.
NOTE : ・If the INSULATION SHEET has been removed, replace with a new sheet.
・ When attaching the INSULATION SHEET, align with the Silk-Print and up to side of the NET-
WORK MODULE PCB.
・Fix with tape in position A.
↓Shooting direction: C↓
↑Shooting direction: D↑
↑Shooting direction: A↑
↓Shooting direction: B↓
1. WiFi ANT
↓Shooting direction: A↓
View from the TOP
INSULATION SHEET
GASKET
INSULATION SHEET
�
�
Glue x2
Proceeding : TOP COVER → FRONT PANEL ASSY
(1) Remove the screws.
(2) Remove the screws. Remove the CORD HOLDER and connectors. Remove the FFC.
2. FRONT PANEL ASSY
View from the bottom
x4
x2
x2x2 x1
FFC FFC
N1021
CP4401
CORD HOLDER
59
Caution in
servicing
Electrical Mechanical Repair Information Updating
To Next Page
Loading...
