15
ENGLISH
RECORDING
This example explains how to record from an input source
such as an Super Audio CD player to a recording device such
as a CD-R.
1. Press the power ON/OFF switch of the Super Audio CD
player and CD-R to activate power to both components.
2. Press the POWER ON/OFF switch q of the PM-15S1 to
activate power to it. Approximately 8 seconds after power
has been activated, the muting turns OFF and audio output
is enabled. When using multiple PM-15S1s connected by
FCBS, turn power ON in the order of lowest to highest ID
number, starting from ID 1.
3. Select the input source from the INPUT SELECTOR knob
e on the PM-15S1 or the input selector buttons z of the
remote controller. And, press the REC OUT button !2 to
turn the recording output of RECORDER 1 and 2 ON.
4. Load a playback disc into the Super Audio CD player and
a recording disc into the CD-R.
5. Start playback on the Super Audio CD player. Then, start
recording on the CD-R.
6. To use the speakers connected to the SPEAKER
SYSTEMS terminals, press the SPEAKERS button !0 on
the PM-15S1.
7. Adjust the volume level from the VOLUME knob r on the
PM-15S1 or the VOLUME 3/4 buttons n of the remote
controller.
Note
When RECORDER 1 is selected as the input source,
signals are not output to the RECORDER 1 OUT jack. The
same goes for the RECORDER 2 OUT jack when
RECORDER 2 is selected as the input source.
BASIC OPERATION
L
TRIM
RC-11PMS1
FM/BAM/A
RETURN
TOP MENU
MENU
VOLUME
CLOSE
MODE
PHONO
CD
BALANCED
RECORDER 1
LINE 1
RECORDER 2
LINE 2
EXIT
TONE
ENTER
DISPLAY
ATT
SCAN
RANDOM REPEAT
+
-
OPEN/ SOUND
R
PM-15S1NENG(P07-P24)A4 05.2.21, 11:05 AMPage 15 AdobePageMaker6.5J/PPC
To Next Page
Loading...
Need help?
General
