Why is the sound coming from the wrong channel on my Marantz Receiver?
If the sound from your Marantz Receiver is coming from the wrong channel, the speaker cable may be connected incorrectly. Refer to the connection diagram and connect the cable correctly.
How to eliminate noise during AM reception on my Marantz Receiver?
If you are experiencing noise during AM reception on your Marantz Receiver, it might be due to interference from other electrical fields. Try changing the location where the AM indoor antenna is set up.
What causes noise during FM reception on my Marantz Receiver?
If you're hearing noise during FM reception on your Marantz Receiver, it could be due to weak radio waves from the broadcasting station. Consider installing an FM outdoor antenna.
Why can't I select EX/ES mode on my Marantz Receiver?
If you cannot select EX/ES mode on your Marantz Receiver, it could be because: * Surround center= NONE has been selected in SPEAKERS SIZE SETUP. Make the correct setting. * The input signal is incompatible. Use a 5.1 channel source.
Why can't I select Pro Logic II mode on my Marantz Receiver?
If you cannot select Pro Logic II mode on your Marantz Receiver, the input signal might be incompatible. Use a 2 channel Dolby Digital input signal, PCM input signal, or analog input signal.
Why can't I select Neo:6 mode on my Marantz Receiver?
If you cannot select Neo:6 mode on your Marantz Receiver, the input signal may be incompatible. Use a 2 channel Dolby Digital input signal, PCM input signal, or analog input signal.
Detailed specifications for FM/AM tuners, audio, and video sections.
Details about the necessary service tool for unit updates.
Explains DTS, Neo:6, Dolby Digital EX, and CS-II audio formats.
Procedures for tuner adjustment and system memory reset.
Instructions for updating CPU and DSP firmware.
Steps to adjust the idling current for optimal power amplifier performance.
Identifies and explains error messages displayed on the unit.
Flowcharts to diagnose and resolve common operational issues.
Explains parts codes, resistor/capacitor identification, and safety notes.
General| Type | Stereo Receiver |
|---|---|
| Total Harmonic Distortion (THD) | 0.08% |
| Signal-to-Noise Ratio | 100 dB |
| Input Sensitivity | 200 mV |
| Headphone Output | Yes |
| Power Output | 100 W per channel (8 ohms) |
| Frequency Response | 10 Hz - 100 kHz |
| Input Impedance | 47k ohms |
| Digital Inputs | Coaxial, Optical |
| Analog Inputs | 6 |
| Analog Outputs | 1 |
| Tuner Section | AM/FM |
To Next Page
