7. Removing the ratchet system on the Super 1050/RL 1100/RL 1050
Figure 8: Removing Ratchet arm
In order to use the Jog functionality of the Mark 7® Autodrive the ratcheting system on the Dillon must
be removed – but that is a decision best made by the user. You can either choose to remove the ratchet
arm Dillon Part #13376 or the toolhead ratchet Dillon Part #11688 or both (recommended) as shown
above. If you remove the ratchet plate make sure to re-install the Cam Guide Bolt Dillon Part # 12486
shown in Figure 8.
To Next Page
Loading...
