25
Remote Control
standby
setup enter
select volume
polarity balance display mute
+
–
MADRIGAL AUDIO LABORATORIES
R
INTEGRATED AMPLIFIER
Nº383
1
2
3
4
5
6
8
7
9
10
11
(on bottom)
1 IR transmission window
Infrared (IR) control signals are sent through this window. Aim
the remote control toward the Nº383 when using the remote. For
the best results, the remote should be within ±45° of a line that is
perpendicular to the faceplate of the Nº383.
At more severe angles (nearly parallel with the faceplate), try
bouncing the remote’s signal off a wall or other surface instead so
as to have it enter the display window of the Nº383 at a reasonable
angle.
Alternatively, use an external infrared receiver, placed in a more
convenient location, to route the signal to the rear panel ir input
jack.
To Next Page
Loading...
