Mark Levinson #52 - Volume Control; Advanced Settings; Factory-Default Settings; Power Management, Advanced

16
N
0
52 RefeReNce PReamPlifieR / Quick-Start Guide
factoRy-default SettinGS
The following are the factory-default settings for the
N
0
52’s Setup menu. For information about all Setup menu
settings see the
N
0
52 User Guide, which can be found on
the supplied USB memory stick.
INPUTS
The following setting defaults apply to all Inputs:
Name: Input X (the selected input connector
number)
Gain: 0dB
Volume Offset: 0.0dB
SSP: Off (Note: SSP is not available for the
Phono input)
Aux: Both
The following additional setting defaults apply only to the Phono
input:
Mono Mode: Off
Phono Gain : +40dB
Phono Balance: 0.0dB
20Hz High-Pass
Filter:
Off
Resistive Load: 47k ohms
Capacitive Load: None
VOLUME CONTROL
Maximum Volume: 80.0dB
Muting Level: –40.0dB
Turn-On Volume
Level:
40.0dB
Volume Taper: Mode 1
POWER MANAGEMENT
Standby Mode: Green
Auto Off: On
ADVANCED SETTINGS
Display Intensity: High
Timer: 10 seconds
Configuration Lock: Off
DHCP: On
Static IP Address: 192.168.50.10
Static Subnet
Address:
255.255.0.0
factoRy-default SettinGS