Mark Levinson 5805 - Page 35

33
N
0
5805 / N
0
5802 INTEGRATED AMPLIFIER / OWNER’S MANUAL
MOVING-COIL MODE
Input Resistance: Selectable, 37Ω to 1000Ω
Gain: 69dB at 1kHz
Total Harmonic Distortion: <0.01%, 1kHz, 2V RMS output; <0.06%, 20kHz, 2V RMS output
Signal-To-Noise Ratio: >71dB (20Hz to 20kHz A-weighted, referred to 2V RMS output);
>66dB (20Hz to 20kHz, wideband, unweighted, referred to 2V RMS output)
Maximum Input Level: >6.5mV at 1kHz; >19mV at 20kHz
DIGITAL-TO-ANALOG CONVERTER STAGE
Output Voltage: 5.7V RMS at maximum volume/full scale (0dBFS)
Frequency Response: 20Hz to 20kHz, +0/–0.05dB (44.1kHz/16 bit signal); 20Hz to 20kHz, +0/–0.02dB (192kHz/24 bit signal)
Total Harmonic Distortion: <0.0025%, 20Hz to 20kHz,at 3V RMS output (192kHz/24 bit signal);
<0.003%, 20Hz to 20kHz, at 3V RMS output (44.1kHz/16 bit signal);
<0.006%, 90kHz, at 3V RMS output (192kHz/24 bit signal)
Signal-To-Noise Ratio: >100dB (20Hz to 20 kHz, 192kHz/24 bit signal, A-weighted);
>98dB (20Hz to 20 kHz, 192kHz/24 bit signal, wideband, unweighted);
>94dB (20Hz to 20 kHz, 44.1kHz/16 bit signal, A-weighted);
>92dB (20Hz to 20 kHz, 44.1kHz/16 bit signal, wideband, unweighted)
Referred to 3VRMS output
Sample Rates/Bit Depth: PCM: 32, 44.1, 48, 88.2, 96, 176.4, 192, 352.8, or 384kHz; up to 32 bits; DSD: Native or DoP; single,
double, or quad speed (2.8, 5.6, or 11.2MHz)
Digital Processing: Full MQA decoding; PCM: Seven user-selectable digital filter settings;
user-selectable up-sampling to 352.8/384kHz; DSD: Four user-selectable digital filter settings
HEADPHONE OUTPUT
Total Harmonic Distortion: <0.04%, 20Hz and 1kHz, 2V RMS output, 30Ω load; <0.10%, 20kHz, 2V RMS output, 30Ω load
Output Overload: >3.3V RMS, 30Ω load
Signal-To-Noise Ratio: >91dB (20Hz to 20kHz, A-weighted, referred to 2V RMS output); >87dB (20Hz to 20kHz, wideband,
unweighted, referred to 2V RMS output
Output Impedance: <2.5Ω, 20Hz to 20kHz
SPECIFICATIONS