MARQUES BM1000 - Overview; First Use; Upkeep

User Guide | BM1000
EN
4 Nov 2023
The BM1000 indicators are weighing indicators with several features appropria-
te for industrial use, including tares, printing tickets, counting scale mode, etc.
FIRST USE
These indicators are supplied as a part of a full weighing equipment. Any addi-
tional configuration (for instance, communication) will have to be done tailored
to the needs of the user.
UPKEEP
The battery should be on full charge as often as possible. The number of times
it can be recharged will depend on the condition of the usage, but there are
several ways of ensuring a correct use of the device:
♦ Avoiding the full discharge of the battery;
♦ Recharging it frequently;
♦ Not overloading it by using components outside of the specification
indicated in this manual
♦ In case it is stored away for long periods of time, recharging it fully at
least once every three months.
In case the battery lasts for less time than predicted, please contact your supplier
so as to take the necessary steps to replace it.
If the fault is attributed to the non compliance of the indications above, it will be
deemed as bad usage; as such, the substitution of the battery will be of the full
responsibility of the owner.
To keep the indicator in good condition, it should be cleaned according to the
following:
1. Turning o the indicator using the ON/OFF key;
2. Disconnecting the indicator from the electrical current, removing the
plug from the socket;
3. Using a clean and dry piece of cloth.
Do not use alcohol, detergents or other such abrasive products to clean the
indicator, as there is a risk of damage.
It’s necessary to avoid water getting into the indicator, as that may damage the
electrical components.
Overview