MARS COMMERCE SOLO–NX - 4 Start up

SOLO-NX
USER MANUAL
Page 6
4 START UP
SOLO-NX unit accepts a standard GSM SIM cards from any network.
VERY
IMPORTANT
USE A MICRO SIM CARD
WARNING
DO NOT Insert or remove the SIM card while the unit is powered ON!!
IMPORTANT
Before inserting SIM card to unit make sure the PIN code is
removed!!
 Insert SIM card in SOLO-NX unit.
 Connect power cable to SOLO-NX unit (YOU MUST POWER THE SOLO UNIT WITH
THE POWER SUPPLY IF INCLUDED. Do not power with any other power supply).
 Power up the unit.
 Wait until LED1 (Blue) starts flashing. This is set in around 30 – 45 seconds.
 SOLO-NX unit is now ready to operate.
NOTE
SOLO-NX device will “beep” in 15s interval until the device is not in normal
operation.