Martin MAC Encore Performance CLD User Manual

34 MAC Encore Performance User Guide
FSER
FRAMING4 INS ERR
Framing blade 4 insertion position error.
FSER
FRAMING4 ANG ERR
Framing blade 4 angle position error.
FTER
FROST ERROR
Frost effect position error.
G1ER
GOBO W 1 ERR
Rotating gobo wheel position error.
IRER
IRIS ERROR
Iris effect position error.
LDTC
LED TEMP CUT OFF
LED board temperature cutoff activated.
LDTE
LED TEMP SEN ERR
LED board temperature sensor error.
MAER
MAGENTA ERROR
Magenta flag position error.
MMER
MISSING MODULE ERR
Impossible to communicate with a module that should be present. Module missing or not
correctly connected.
NLCI
NO LED COLOR INFO
Fixture unable to retrieve LED color/type information.
PAER
PA N E R RO R
Pan position electrical indexing system timeout.
PFTC
PFC TEMP CUT OFF
Power factor correction system temperature cutoff.
PFTE
PFC TEMP SEN ERR
Power factor correction system temperature sensor error.
PSER
PAN SENSOR ERROR
Fixture unable to retrieve reliable data from pan position sensor.
PTCM
PT SENSOR ADJUST
Pan/tilt sensors are incorrectly adjusted.
PTTC
PT TEMP CUT OFF
Pan/tilt temperature cutoff activated.
PTTE
P/T SENSOR ERROR
Pan/tilt sensors are incorrectly adjusted.
PUTC
PSU TEMP CUT OFF
PSU temperature cutoff activated.
PUTE
PSU TEMP SEN ERR
PSU temperature sensor error.
R1ER
GOBO W 1 ROT ERR
Rotating gobo wheel indexing position error.
RFER
FRAM ROT ERROR
Framing module indexing position error.
SLER
SAFETY LOOP
Safety loop circuit activated. A temperature circuit breaker has shut down LEDs. Circuit breaker
resets automatically after temperature has returned to normal operating range.
TIER
TILT ERROR
Tilt position electrical indexing circuit timeout.
TSER
TILT SENSOR ERR
Fixture unable to retrieve reliable data from tilt position sensor.
UECM
UPL ERR CMY
Could not upload new CMY effect system firmware during a firmware upload. Error cleared
when new firmware is uploaded successfully or power is cycled off and on.
UEEF
UPL ERR EFFECT
Could not upload new effects systems firmware during a firmware upload. Error cleared when
new firmware is uploaded successfully or power is cycled off and on.
UELD
UPL ERR LED DRV
Could not upload new LED driver firmware during a firmware upload. Error cleared when new
firmware is uploaded successfully or power is cycled off and on.
Short code
Long message and explanation
Table 5: Error messages

Martin MAC Encore Performance CLD Specifications

General

Brand	Martin
Model	MAC Encore Performance CLD
Category	DJ Equipment
Language	English