Safety Information
The following symbols are used to identify important safety information on the product and in this document:
Warning! The MAC Quantum Wash™ contains components that are accessible and live at high
voltage while the fixture is connected to power. These components remain under tension for up to
30 minutes after power is disconnected. Only technicians who are authorized by Martin™ and who
have access to the Martin™ service documentation for the MAC Quantum Wash are permitted to
open the fixture.
Warning! Risk Group 2 product according to EN 62471. Do not view the light output with optical
instruments or any device that may concentrate the beam.
The latest versions of this Safety and Installation Manual and the MAC Quantum Wash User Guide are
available for download from the MAC Quantum Wash Product Support page on the Martin™ website at
www.martin.com. Before you install, operate or service the MAC Quantum Wash, check the Martin™
website and make sure that you have the latest user documentation for the fixture. Document revisions are
indicated at the bottom of page 2. Follow the safety precautions and observe all warnings in this manual, in
the MAC Quantum Wash User Guide, and printed on the fixture.
This product is for professional use only. It is not for household use.
Respect all locally applicable laws, codes and regulations when installing, powering, operating or servicing
the fixture.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock and falls.
If you have questions about how to operate the fixture safely, please contact your Martin™ supplier or call
the Martin™ 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
PROTECTION FROM ELECTRIC SHOCK
• Do not remove any cover from the fixture except as described under “Service and maintenance” on
page 12.
• Disconnect the fixture from AC power before servicing it and when it is not in use.
• Ensure that the fixture is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• The power input cable must be rated 20 A, hard usage type and heat-resistant to 90° C (194° F)
minimum. It must have three conductors and an outer cable diameter of 5 - 15 mm (0.2 - 0.6 in.). In North
America the cable must be 12 AWG minimum conductor size, type SJT or equivalent. In the EU the cable
must be 2.5 mm² minimum conductor size, type H05VV-F or equivalent.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
WARNING!
Read the safety precautions in this section before
installing, powering, operating or servicing this
product.
DANGER!
Safety hazard.
Risk of severe
injury or death.
DANGER!
Hazardous
voltage. Risk of
lethal or severe
electric shock.
WARNING!
Fire hazard.
WARNING!
Burn hazard. Hot
surface. Do not
touch.
WARNING!
Intense light
emission.
WARNING!
Refer to user
manual.
To Next Page
Loading...
Need help?
General
