Summarizing tables
MZ034
English
6
163
Table 18 - 888
888
888 RC2X - 888 RC2 - 888 VF2 - 888 VF
Legs’ diameter ø 35 mm
Available travels 170 mm - 200 mm
Wheel dropout type ø 20mm through-hole axle
Max disk dimension
XC INTL STD 6” (The installation of 8" disk is only possible when the specific adapter
is supplied by the brake system manufacturer
)
V-brake fit No
Max wheel
dimensions
2.8” x 26”
888 RC2X 888 RC2
Spring preload by external adjuster - Both legs (RC2X)
Spring preload by external adjuster - Right leg (RC2)
By turning the knob clockwise, you increase the preload value while
reducing the air volume inside the fork’s leg.
By turning the knob counter-clockwise, you reduce the preload value
while increasing the air volume inside the fork’s leg
888 VF
Rebound adjustment by internal adjuster - Right leg
Unscrew and remove the protection cap with a 26 mm cap key.
Insert a 3mm Allen key into the stanchion being very careful to center
the notch of the adjuster.
By turning the adjuster counter-clockwise, you increase the hydraulic
damping making the fork slower during the rebound phase.
By turning the adjuster clockwise, you reduce the hydraulic damping
making the fork more reactive during the rebound phase.
After adjustment, refit and tighten the protection cap to the
recommended tightening torque.
Re-inflate to the recommended air pressure value.
888 VF2
Rebound adjustment by external adjuster - Right leg
By turning the adjuster clockwise, you increase the hydraulic damping
making the fork slower during the rebound phase.
By turning the adjuster counter-clockwise, you reduce the hydraulic
damping making the fork more reactive during the rebound phase
To Next Page
Loading...
