OWNER’S/OPERATOR’S MANUAL 20.0
7. CONTROL AND PARTS FUNCTIONS
7- 7
SEATS
1.Drive seat
2.Passenger seat
To remove a seat, lift the rear of the seat,
and then slide the seat up and backward.
To install a seat, push down on the seat at the
front and insert the projections on the rear of
the seat into the seat holders.
WARNING
POTENTIAL HAZARD
A loose seat.
WHAT CAN HAPPEN
The operator could lose control or the operator or passenger could fall if
the seat is loose during operation.
HOW TO AVOID THE HAZARD
Make sure the seat is securely latched.
SEAT BELTS
1.Seat belt (×2)
2.Latch plate (×2)
3.Buckle (×2)
This vehicle is equipped with
three-point seat belts for both
the operator and passenger.
Always wear the seat belt while
riding in the vehicle.
To Next Page
Loading...
