NOTE:
( At the little voltage range, the meter will show unsteady reading when test leads haven ’ t reach the circuit,
it ’ s normal because the meter is very sensitivity. When test leads touch the circuit, you can get the true
reading.
( At the manual range mode, when only the figure ‘ OL
’
is displayed, it indicates overrange situation and
the higher range has to be selected.
( At the manual range mode, when the value scale to be measured is unknown beforehand, set the range
selector at the highest position.
4.12 MEASURING DC CURRENT
WARNING
Shut down the power of the tested circuit, then
connect the meter with the circuit for
measurement.
To Next Page
Loading...
