Mastech ms6231 - Continuity Test

figure ‘ OL ’ will be displayed.
( When the input is not connected, i.e. at open circuit, the figure ‘ OL ’ will be displayed.
4.22 CONTINUITY TEST
WARNING
When testing the circuit continuity, be sure that
the power of the circuit has been shut down and
all capacitors have been discharged fully.
4.22.1 Connect the black test lead to the COM jack and the red test lead to the INPUT jack.
4.22.2 Set the transform switch at the range position.
4.22.3 put down the "FUNC." transformed at continuity test.
4.22.4 Connect test leads across two points