4.17 MEASURING TEMPERATURE （ ℃ ）
WARNING
To
avoid electrical shock, do not connect the
thermocouples with the electriferous circuit.
4.17.1 Set the transform switch at the TEMP range position.
4.17.2 Put down the "FUNC." to enter the ℃ measurement.
4.17.3 The LCD display will show the current environment temperature.
4.17.4 When measuring the temperature with thermocouple, ‘ K
’
type probe for this meter can be used.
Insert the black plug to the COM jack and the red one to the INPUT jack, touch the end of the
temperature sensor to the area or surface of the object for measurement.
4.17.5 You can get reading from LCD.
NOTE:
( With better hermetization, the meter ’ s temperature measured circuit and environment need a little
longer time to reach heat balance, and then accurate reading can be gotten.
4.18 MEASURING TEMPERATURE （ ℉ ）
WARNING
To
avoid electrical shock, do not connect the
thermocouples with the electriferous circuit.
4.18.1 Set the transform switch at the TEMP range position.
4.18.2 Put down the "FUNC." to enter the ℉ measurement.
4.18.3 The LCD display will show the current environment temperature.
4.18.4 When measuring the temperature with thermocouple, ‘ K
’
type probe for
To Next Page
Loading...
Need help?
General
