higher range has to be selected.
( When the value scale to be measured is unknown beforehand, set the range selector at the highest
position. ( “ ” means the socket of 10A jack maximum current is 10A, no fuse protection.
4.15 AC CURRENT MEASURING (WITH CLAMP , OPTIONAL)
4.15.1 Connect the black output lead of clamp to the COM jack and the red one to the INPUT jack of the
meter.
4.15.2 Set the transform switch at the “ ” range position.
4.15.3 Put down the "FUNC." to enter the AC measurement. Auto range or manual range can be
transformed by putting the “ RANGE ” .
4.15.4 Clamp the circuit under measured.
4.15.5 You can get reading from LCD.
NOTE:
( At the manual range mode, when only the figure ‘ OL
’
is displayed, it indicates overrange situation and
To Next Page
Loading...
Need help?
General
