MS8218 True RMS Multimeter
Operation Methods
the minimum value, the maximum value
-
minimum value or the maximum value. When the meter being in the maximum
and the minimum value record state, the analog bar is always indicating the present measurement value but not the MAXIMIN
value. Under the maximum and minimum value record state, press the MAXIMIN key for two seconds and then release it, the
meter will exit the MAXIMIN record state. When measurement over, OL will display instead of showing the MAXIMIN value.
Backlight Control
Pressing the LIGHT key, the LCD display screen's backlight will be lighted and after five seconds it will automatically go out.
If press the LIGHT key again when the backlight is lighting, the backlight can be turned off in advance. Lighting the backlight
will cause three-times higher energy consumption than the ordinary operation. So by less use of backlight, power can be saved.
Data Hold
By pressing the HOLD key it is possible to hold the measurement value and the state at the moment of pressing the HOLD key.
While pressing the key again data measurement will be resumed.
Automatic Shutdown and Continuous Operation Mode Selection
After turning on power, the meter will in default enter the auto-shutdown timing state. Within IS minutes after stopping to press
any key or turn the rotary switch, the meter will automatically turn off. After auto-shutdown, by pressing the WAKE key or
turning the rotary switch it is possible to wake the meter to resume operation. If you want the meter operates continuously
without shutdown, it will be done by pressing the WAKE at the same time when turning on power.
36
To Next Page
Loading...
Need help?
General
