MS8218 True RMS Multimeter
Safety Information
potential during measuring. The body should be kept insulated from ground with dry insulating shoes, insulating pads or
insulating clothes.
•
When performing measurement with a test probe your fingers should be put behind a finger-protector.
•
Must not try to measure a voltage higher than 1000VAC or 1000VDC,the meter may be damaged and the operator's safety
may be threatened if the limit for voltage measurement be exceeded.
•
when the symbol for electric insufficiency appearing on the display screen it is necessary to replace the batteries for
avoiding the possible shock or injure resulted in by erroneous reading.
•
In
case of replacing batteries, it is necessary firstly to pull out the testing line. AA batteries should be used and they should
be put into the meter with the proper polarity.
•
Must not make any voltage measurement when the testing line being inserting into the current hole.
•
Repair and calibration of the meter must be carried out by experienced professionals, unprofessionals should not repair and
calibrate the meter by themselves.
Limited Guarantee and the Liability Scope
This company will undertake repairs freely for any quality problem of the meter which if should be found within
18
months
from the date at which it was bought, but which not including replacement of fuse and batteries as well as any damage caused
by negligence, wrong use, pollution, change of circuit and non-normal use.
For maintenance beyond the 18-month guarantee period, the company will charge a certain repair fee and materials cost.
2
To Next Page
Loading...
Need help?
General
