MS8218 True RMS Multimeter
Maintenance
Meter Calibration
There is no any component which can be used for calibration in the meter, calibration of the meter is implemented depending
on the built-in software in the meter. Professionals and accuracy-even-higher standard signal sources are required for
calibration of the meter. Users possessing such conditions may contact us for calibration methods when there is a need on
calibration meter, while those who having not such conditions can contact us for calibration matters.
Others
•
In
case of any default being found this meter must not be used continuously.
•
When the meter needs repair, please send it to experienced professionals or the appointed maintenance department for
repamng.
• It
should use soft cloth but not organic solvents which have corrosive and dissolving effect on the shell of meter to clean the
meter, and it should guard against water dropping into the meter.
44
To Previous Page
Loading...
Need help?
General
