MS8218 True RMS Multimeter
Introduction to the Meter
(1)
V OHz end
It
is the input end for all measurement functions except for current measurement, connected with a red meter probe.
(2) COM end
It
is the negative input end for all measurements, connected with a black meter probe.
(3)µA/rnA end
It
is the positive end for measurement of µA or mA current, connected with a red meter probe.
(4)A end
It
is the positive input end for measurement of 0.SA-I0A current, connected with a red meter probe.
(S)Rotary switch
Used for selecting measurement functions such as voltage, current, resistance and Capacitance.
(6)POWER switch
U sed for putting on or off the operating power for the meter.
(7)RANGE key
For various kinds of measurements it is used manually to select range. Under the automatic range state (AUTO displaying), it
will enter manual range state(MANUAL displaying) with a press on RANGE, after that the range will be changed with a press
on RANGE while the small digits on the left lower corner indicating the actual range. When the RANGE key being released
after pressing for two seconds the meter will return back to the automatic state. When performing logic frequency measurement
and diode measurement pressing RANGE will be void. During dBm measurement, pressing RANGE key will alter the virtual
resistance value for calculating dBm.
5
To Next Page
Loading...
Need help?
General
