Master Chef G70220 - Match-Lighting - Burners; Shut Down Procedure

10
LIGHTING INSTRUCTIONS
MATCH-LIGHTING — BURNERS
Repeat steps 1-3 “Lighting Burners” above.
4. To match light, push in and turn the far right control knob counter-
clockwise to the MAX/“05” position.
5. Immediately strike a match or use a butane lighter, and position it
through the lighting hole on the right side of the firebox. Check to
ensure that the burner is lit.
6. Repeat step 4 and 5 to light the remaining burners.
CAUTION
If ignition does NOT occur in 5 seconds, turn the control knobs OFF/“O” and wait 5 minutes and repeat the lighting
procedure. If the burner does not ignite with the controls in the on position, beware that gas will continue to flow out of
the burner and could accidentally ignite with risk of injury. Turn control knobs and gas source “OFF” before attempting to
re-light.
ATTENTION
Always preheat griddle before starting to cook. Light all burners and adjust them to the MAX/“05” position for 10 minutes.
Following preheat; adjust the controls to appropriate setting.
1. Turn all control knobs OFF/“0” position (see image A).
2. Turn LP cylinder ”OFF” by turning handle wheel clockwise to full stop (see image B).
A
B
SHUT DOWN PROCEDURE