CAUTION: TO PREVENT PERSONAL INJURY:
• ALWAYS DISCONNECT THE PLUG FROM THE POWER SOURCE WHEN MAKING ANY
ADJUSTMENTS.
• THIS ADJUSTMENT MUST BE CORRECT, OR KICKBACK COULD RESULT IN A
SERIOUS INJURY AND INABILITY TO MAKE ACCURATE CUTS.
V. Assembly and adjustments(continued)
20
BLADE TILT POINTER
1. When the blade is positioned at 90°, adjust the blade tilt pointer read 0° on the scale.
2. Loosen the holding screw, position the pointer over the 0°, and tighten the screw.
NOTE: Make a trial cut on a scrap piece of wood before making critical cuts. Measure for
exactness.
To Next Page
Loading...
