Masterflex MASTERSENSE MFLX07526-10 - Cleaning the Pump Drive

5-2 MasterSense™ L/S
®
Digital Pump Drive with Advanced Connectivity
Section 5: Service & Maintenance
Masterflex
CLEANING THE PUMP DRIVE
!
CAUTION: Unplug the pump drive’s power cable from the mains power outlet when cleaning
or performing maintenance on the drive.
If required, the pump drive may be wiped clean using a soft cloth lightly moistened with either isopropyl or
ethyl alcohol.
NOTE:
• Care should be taken with the pump drive’s touchscreen to avoid scratching or otherwise damaging the
surface. Do not wipe with dry or abrasive material.
• Do not operate the pump drive with water on the surface of the touchscreen.
• Any damage caused by improper cleaning will be the sole responsibility of the customer.
ACCESSORIES
To purchase accessories or for further information visit www.master ex.com.  e following accessories are
available for the L/S Digital Pump Drive:
Description Part Number
Footswitch w/DB-25 male 07523-92
Connector DB-25 male 07523-94
Cable assembly DB-25 male connector and 25 ft (7.9 m) cable with stripped
wire ends
07523-95
Dispening Wand DB-25 07523-97
Footswitch (NEMA)* 07575-84
Remote Control Cable (NEMA)*, 25-ft (7.62m) 07575-80
Interface Cable DB9M/DB9F 22050-54
Cable USB Type A/Type B M/M 22050-60
REPLACEMENT PARTS
Description Part Number
Fuse-T3.15A, 5 x 20 mm 77500-25
Gear Service Kit (600 rpm) 07553-06
Gear Only (600 rpm) 07553-09
Gear Service Kit (100 rpm) 07553-08
Replacement Seal Kit (NEMA)8 07575-01
Replacement Gear and Shaft Kit (NEMA)* 07575-02