ChargeMaster Plus 12/75-3, 12/100-3, 24/40-3, 24/60-3 –
User and Installation Manual
3.8 Installation step-by-step
Fix the enclosure to the wall by fastening two
screws at the lower side of the enclosure as
well.
Open the connection compartment by
loosening the two screws.
Connect the wiring to the screw terminals.
Fasten the cable with the cable clip.
Fit crimp-on ring terminals to the DC cables.
Connect the DC cabling of battery bank 1,
positive to +, negative to – .
If needed repeat steps for output 2 and 3.
To Next Page
Loading...
