Matrix A7XI-01 - Troubleshooting - Error 0148

67
8.9 TROUBLESHOOTING - ERROR 0148
CHAPTER 8: TROUBLESHOOTING
ERROR CODE 0148
1) SYMPTOM:
0148 – Incline motor over current.
2) SOLUTION:
1) Follow the instructions in Section 3.5 to run Auto Calibration (Figure B).
2) Disconnect the incline tube from the incline frame (Figure A), then turn on the power.
- If the console still shows 0148, replace the incline motor.
- If the console does not show 0148, follow the incline motor installation procedure in Section 9.13 to re-attach the incline motor.
3) Replace the LCB.
FIGURE A FIGURE B