Matrix G7-S70 - Cam

14
STEP 1 | CAM & CABLE ASSEMBLY INSTRUCTIONS & NOTES
ID DESCRIPTION QUANITY
5 M10 Nylock Nut 1
12 M10 Flat Washer (22 mm Diameter) 2
17 M10 X 105L SHC 1
18 CAM(W/UserFrameCableAttached) 1
ASSEMBLY
PART 2: CABLE ASSEMBLY
• Remove CAM plate
• Assemble cable into CAM
as shown
• Capture cable end with
retaining “U” clip
• Using two hex wrenches,
reassemble CAM plate
andtorquefastenersto:
39N-m/29ft-lbs.
5
5
12
18
• TorqueM10centerbolt
to:77N-m/57ft-lbs.