Matrix S-Drive - Page 24

22
cHaPTer 6: TreaDmill SPecificaTionS anD aSSembly GUiDe
6.3 aSSembly inSTrUcTionS - conTinUeD
G
F
E
2
1
H
STeP 5
STeP 6
A. Carefully pull the cable (1) through the riGHT HanDlebar
SUPPorT using the twist tie located inside the riGHT
HanDlebar SUPPorT and attach to the connecTor
cable (2) on the main frame.
B. Repeat on other side.
C. Completely tighten hardware from steps 2–5 according to the
TorqueValuesspecifiedineachstep
D. Tighten the lock nuts on the cables using 2 open-end 8mm
wrenches.
GreenHardwareBags(x2)
Description Qty
E
F
G
Bolt
Flat Washer
Bolt
4
4
2
Note:
Step5TorqueValue:39.2Nm/28.9ft-lb
YellowHardwareBag
Description Qty
H Screw 2